Metal roofs handle the humid continental swings here better than shingles. Cold snowy winters pile up ice dams along the eaves in places like Longfellow and Powderhorn. We use 24-gauge Galvalume standing seam panels with hidden clips to let the metal expand and contract without leaks. Cheap crews skip the thermal breaks and you end up with condensation stains on ceilings by spring.
Common failure points show up on older Minneapolis stock around the North Loop. Original wood decks sag under the weight of added insulation and the metal sheets start oil-canning. We sister in new 2x6 rafters where needed and fasten at every rib with gasketed screws rated for our freeze-thaw cycles. Hennepin inspectors check the snow-load ratings on every permit.
Warm humid summers bring UV and pollen buildup that eats cheap paint jobs fast. We specify Kynar 500 finish on the panels so they hold color after ten summers. Homeowners in Camden and Phillips often call after a big storm because the old screw-down panels lifted at the seams. We replace just the damaged runs instead of the whole roof when the underlayment is still sound.
Metal Roof Snow Load Checks
We measure rafter spacing and add collar ties before any metal goes on. This keeps the roof from bowing during the worst January storms near Target Field.
Metal Roofing Services We Offer
✓Standing Seam Metal Roof Installation Minneapolis
We install 24-gauge standing seam panels with hidden fasteners on homes in Uptown and Southwest. The job takes three to five days once the deck is prepped.
✓Emergency Metal Roof Leak Repair Minneapolis
We patch holes and re-seal seams on metal roofs in Cedar-Riverside within 24 hours. Most fixes use matching Galvalume pieces so the patch blends in.
✓Metal Roof Replacement Over Shingles Minneapolis
We lay new metal right over existing shingles on houses in Phillips and Near North when the deck is solid. This cuts labor time and keeps debris out of the yard.
✓Commercial Metal Roofing Installation Minneapolis
We put up screw-down metal panels on small commercial buildings near the Mall of America. Jobs include proper ridge vents and eave trim rated for Hennepin wind loads.
✓Metal Roof Panel Replacement Minneapolis
We swap out dented or rusted panels on roofs around Lake Harriet without tearing the whole thing off. New panels match the existing gauge and color.
Metal Roofing Cost in Minneapolis, MN
| Service | Typical Range | What Affects It |
|---|---|---|
| Install standing seam metal roof on 1,500 sq ft house | $12,000–$18,000 | Higher end when we tear off two layers and sister rafters. |
| Replace damaged metal panels only | $450–$950 | Price per panel run depends on access and matching color. |
| Fix ice dam leaks on metal roof | $600–$1,400 | Includes new step flashing and seam sealant. |
| Commercial metal panel install per square | $650–$950 | Includes ridge vents and wind-rated trim. |
| Free metal roof estimate | Free | Call during business hours or use 24/7 emergency line. |
Ranges are typical for Minneapolis, MN and confirmed with an exact written quote before any work starts.
How it works
- 1
Site Walk and Measure
We check the deck, rafters, and flashing on site. Takes one to two hours.
- 2
Permit and Material Order
We pull the Hennepin permit and order 24-gauge panels. Lead time runs five to seven days.
- 3
Tear Off or Overlay Prep
We strip old material or clean the deck and add ice-and-water shield at the eaves. One to two days.
- 4
Panel Install and Trim
We set the standing seam panels, install ridge cap and step flashing. Two to four days depending on roof size.
- 5
Final Walk and Cleanup
We check every seam and magnet-sweep the yard. Same day as finish.
Pricing
Prices depend on roof size, pitch, and whether we overlay or tear off.